AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Totem pole output8/24/2023 That drive capability guarantees each TTL output the capability to drive 10 TTL inputs with a guaranteed noise margin of 400mV or greater. TTL outputs will be 400mV or less when low (and sinking 16mA or less), and 2.4V or more when high (and sourcing 400uA or less). TTL inputs are defined as 'low' if they are less than or equal to 800mV and 'high' if they are greater than or equal to 2V. Without the collector resistor it would behave more like a few ohms (1.6K divided by the current gain of Qp). Totempole output can both sink and source. The high or low level is determined without setting pull-up resistance to the output. When Qs is 'off', the base of Qp is pulled to Vcc by Rc, so the effective pullup resistance is limited by the collector resistance Rcp - so it's about 120\$\Omega\$, meaning that for a 50pF load, the time constant is about 6ns. What is totem pole open collector output Totempole output has an output circuit with two transistors combined between VCC and GND. Totem pole outputs like this one use an active pullup, which is Qp, Rc and Rcp. It's a component part of the (active) pullup circuit, but it's not a 'pullup resistor'. ![]() The primary purpose of the 120\$\Omega\$ resistor is to reduce the current spikes when the output switches (when Qo and Qp are both on simultaneously for a brief moment).
0 Comments
Read More
Leave a Reply. |